Edelbrock Intake Manifold
Page 1 of 1

Author:  RobbMc [ Fri Aug 03, 2018 12:20 pm ]
Post subject:  Edelbrock Intake Manifold

Used Edelbrock "F351 2V" aluminum intake manifold for '70-'74 Ford 351 Cleveland V8 with 2V cylinder heads.
This manifold works best from idle to about 5500 rpm.
Good condition. All threaded holes good although one has been repaired with a threaded insert.
Not milled or modified. I cleaned it to remove any oil or dirt.
This intake is nearly identical to the newer "Performer" 2V.
I removed this intake from my engine only because I installed a different intake more suited for higher rpm.
$125 firm.
I can ship via USPS to any USA address for $50 or less, depending on the distance.

RobbMc Performance Products LLC

Author:  RobbMc [ Wed Sep 12, 2018 10:56 pm ]
Post subject:  Re: Edelbrock Intake Manifold


Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group